Electrical Systems

The AC/DC electrical system is designed for redundant backup and international operation.

  • 12,000W toroidal isolation transformer accepts 120/240 VAC – 50/60 Hz shore power.
  • Internally the boat is wired for dual 110/220 VAC system for worldwide use.
  • 24 VDC ships systems with three DC-DC converters for 12 VDC equipment.
  • All systems are isolated by vapour proof Blue Sea master switches.
  • Shore power master breaker is GFI (RCI) type for safety.
  • Visual and audio warnings for all system malfunctions including high engine room water, engine water flow, engine room overheat, any bilge pump running and engine room lights and blower.
  • All wiring is multi-strand tinned copper boat cable.
  • Wire runs in conduit, and all runs with the exception of the bilge pumps, are located as far above the waterline as possible.
  • All wire runs including those along the sheer are easily accessible.
  • Lightning protection system.
  • 16 zinc’s on hull, standard size, bolted, not welded.
  • Jabsco 146SL remote controlled searchlight with helm control.
  • Two Victron DC-DC converters (60A) for 12 VDC electronics.
  • Dual Victron MultiPlus 3kVA inverter/chargers.
  • Victron Digital Multi Control panel to remotely set the shore current, read out the system status and to turn on and off the MultiPlus 3kVA inverter/chargers.
  • Victron Centaur 24/100 charger for the house battery bank.
  • Victron Centaur 12/40 charger for the genset start battery.
  • Victron BMV-501 battery monitor with remote temperature sensor to monitor charging of the house and main engine start banks.
  • Samlex America ACR-160 battery separator for house and start batteries.
  • Six Fullriver DC260-12 batteries for a total of 24 VDC/780 AHr house battery bank.
  • Two Optima® Bluetop® 34M main engine start batteries.
  • One Optima® Bluetop® 34M generator start battery.
  • Start/House battery parallel system-start the main engine from house battery bank if required.
  • 24 VDC, 110 VAC & 220 VAC systems all independently monitored.
  • Carling switches/circuit breakers throughout.
  • Numerous 24 VDC, 12 VDC, 110 VAC and 220 VAC outlets.
  • Marinco stainless steel 50 Amp 125/250 VAC power inlet.
  • Four 200-watt solar panels and Outback FLEXmax 80 MPPT charge controller with Outback MATE2 remote system controller and display.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s